Stain Guard 5000

(4 customer reviews)


SKU: N/A Categories: , , , , , ,

Stain Guard 5000 is suitable for use on unglazed tile, all porous natural and fabricated stone, most dense natural and fabricated stone (if water will soak into the surface), grout, and is specially formulated for granite, and marble.  Stain Guard 5000 will repel a large variety of stains including ketchup, mustard, red wine, citrus stains, grape juice, soda pops, mild acids, dyes, and even graffiti.  Stain Guard 5000 is a permanent impregnating seal and requires only one application for a LIFETIME.

Application Instructions

  1. Read the entire label before using it.

  2. Always test the product in an inconspicuous area to determine suitability.

  3. Clean all surfaces and remove all traces of dirt, dust, efflorescence, mold, salt, grease, oil, laitance, paints or coatings.

  4. Use a spray bottle to apply the product or, for larger applications, use a low-pressure pump type sprayer with a fan tip.  Sensitive areas may be treated with a 1” brush.

  5. Horizontal surfaces should be sprayed liberally until product puddles or ponds on the surface.  After 10 minutes, sweep or squeegee remaining material to dry areas.  If there are no dry areas wipe excess material up with a clean cloth or mop.

  6. ON ANY MARBLE SURFACE THERE IS A POSSIBILITY OF LANDING MARKS WHEN SPRAYING PRODUCT.  Marble application is as follows:  Apply Stain Guard 5000 using a cotton towel, paint pad, or soft sponge.  Be sure to remove any material that does not penetrate the surface within 5 minutes, using paper towels or cotton towels.  Gently “buff” surface with a clean cotton towel upon completion.  Wait for a minimum of 30 minutes for re-application if needed (usually is not needed).

  7. Vertical surfaces should be treated by using a wet on wet application starting from the bottom and moving up the surface allowing a 6-8 inch run down from the bottom of the spray pattern.

  8. Keep dry and allow to cure for 24 hours.


  1. Should not be allowed to dry on glass, as the product will leave a film.

  2. DO NOT spray the product onto marble as the possibility of “landing marks” exists.  Application on marble is specified above, and should ONLY be done according to the above instruction concerning marble.

  3. Protect adjacent surfaces from overspray.

  4. Maybe mildly irritating to skin use caution when applying product.

  5. Do not take internally.

  6. Should not be used as a below-grade waterproofer.

  7. In outdoor applications, if rain has preceded application allow the surface to dry 24 hours prior to application.

  8. Do not apply on exterior surfaces when rain is expected within 6 hours of application.

Additional Info

Stain Guard 5000 is water-based and environmentally friendly and qualifies for LEEDS credits in many applications.  Stain Guard 5000 is a very low V.O.C. formulation and is effective on the interior and exterior surfaces.


Additional information

Weight N/A

16oz, 32oz, 1gal

4 reviews for Stain Guard 5000

Based on 4 reviews
5 star
4 star
3 star
2 star
1 star
  1. John M. (verified owner)

    Very good customer service and advice!

    (0) (0)
  2. Lisa G. (verified owner)

    Great product. Easy to use

    (0) (0)
  3. Mark Piegari (verified owner)

    Thank You

    (0) (0)
  4. David S. (verified owner)

    Delivered Quickly, easy to apply and looks great.

    (0) (0)

Only logged in customers who have purchased this product may leave a review.