Sealer/Adhesive Remover


SKU: N/A Category:

VanHearron’s Sealer & Adhesive Remover is specifically built to ‘break down” coatings as it chemically degrades adhesion properties. Formulated for long dwell time on more difficult jobs. Removes adhesive coatings, deep-set stain, grease, lacquers, waxes, varnishes and more. Just rinse clean with water. Powerful water base.

Interior / Exterior use.

Application Instructions

Surface Preparation: Read the entire label before using it. Provide good air ventilation to the room or area of application. Sweep or vacuum surface. Apply a liberal amount of Sealer and Adhesive Remover to a small, manageable area of up to 25 ft (2 M). Spread with a mop or brush. Allow product to dwell up to 1 hour without drying or until coating or residue softens. Do not allow Sealer and Adhesive Remover to dry on the surface – if remover starts to dry, add more to ensure the surface is kept wet. Agitate with a scrub brush or scrub machine. Wipe up residue with clean, absorbent white cotton towels. A wet/dry vacuum may be used. Removal of thick coatings or residue may require several applications – repeat steps 3 through 7 if the coating is still on the surface. Rinse thoroughly with clean water. Ready for surface traffic in 1 hour or after the surface is dry to the touch. Allow at least a 24-hour drying time before applying Sealer and Adhesive Remover.

CLEAN UP: Thoroughly rinse application equipment with water before material dries.



Wear skin and eye protection. If in eyes, flush with water for at least 15 minutes. If on the skin, wash with soap and water. If irritation persists, seek medical attention. If swallowed, DO NOT induce vomiting, seek medical attention.

USE CHEMICAL-RESISTANT GLOVES, such as nitrile, when handling the product.


Additional information

Weight N/A

32oz, 1 gal


There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.